Liberty 2WD V6-3.7L (2008)
Hydraulic Control Assembly - Antilock Brakes: Removal and Replacement
Hydraulic Control unit (HCU) - Installation
INSTALLATION
NOTE: If the ABM module is being replaced with a new ABM module it must be reprogrammed with the use of a scan tool.
1. Install ABM (2) on the mounting bracket rubber pockets (1).
2. Install brake lines to the ABM (2) and tighten to 20 Nm (180 in. lbs.).
3. Install wiring harness connector to the ABM and push down on the release to secure the connector.
4. Install negative battery cable to the battery.
5. Bleed ABS brake system See: Brake Bleeding.
Hydraulic Control unit (HCU) - Removal
REMOVAL
1. Install prop rod on the brake pedal to keep pressure on the brake system.
2. Remove negative battery cable from the battery.
3. Pull up on the ICU harness connector release and remove connector.
