Liberty 2WD V6-3.7L (2008)
2. Position the recirculation door actuator to the side of the air inlet housing (3). Make sure the actuator output shaft is properly aligned to the
recirculation door pivot shaft. If necessary, rotate the actuator slightly to engage the splines on the output shaft with those in the pivot shaft.
3. Install the two screws (2) that secure the recirculation door actuator to the air inlet housing. Tighten the screws to 1.2 Nm (10 in lbs.).
4. On RHD models, install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel - Installation.
5. On LHD models, install the glove box binSee: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Instrument
Panel Glove Box - Installation.
6. Reconnect the negative battery cable.
7. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test.
