Liberty 2WD V6-3.7L (2008)
NOTE: LHD model shown. RHD model similar.
1. Remove the cowl grille See: Body and Frame/Grille/Service and Repair/Grille - Removal.
2. Remove the two nuts (2) that secure the air inlet screen (1) to the cowl panel (3).
3. Slide the air inlet screen inward to disengage the screen from the two retaining studs (4) and pull the screen straight up to remove it from the cowl.
Air Inlet Screen Installation
SCREEN-AIR INLET
NOTE: LHD model shown. RHD model similar.
1. Position the air inlet screen (1) into the cowl panel (3) and fully engage the screen onto the two retaining studs (4).
2. Install the air inlet screen onto the cowl panel and install the two retaining nuts (4). Tighten the nuts to 2.3 Nm (20 in. lbs.).
3. Install the cowl grille See: Body and Frame/Grille/Service and Repair/Grille - Installation.
HVAC Housing - Removal
HOUSING-HVAC
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in an accidental airbag deployment and possible personal injury or death.
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution. Failure to follow the warnings and cautions could result in possible personal
injury or death.
NOTE: The HVAC housing must be removed from the vehicle and disassembled for service of the A/C evaporator.
NOTE: LHD model shown in illustrations. RHD model similar.
