Liberty 2WD V6-3.7L (2008)
Compass: Procedures
Compass Demagnetizing
COMPASS DEMAGNETIZING
DEGAUSSING TOOL #6029
A degaussing tool (Special Tool 6029) is used to demagnetize, or degauss, the overhead console forward mounting screw and the roof panel above the
overhead console. Equivalent units must be rated as continuous duty for 110/115 volts and 60 Hz. They must also have a field strength of over 350 gauss
at 7 millimeters (0.25 inch) beyond the tip of the probe.
To demagnetize the roof panel proceed as follows:
1. Be certain that the ignition switch is in the Off position, before you begin the demagnetizing procedure.
2. Place a piece of paper approximately 22 by 28 centimeters (8.5 by 11 inches), oriented on the vehicle lengthwise from rear to front, on the center
line of the roof at the rear liftgate. The purpose of the paper is to protect the roof panel from scratches, and to define the area to be demagnetized.
3. Connect the degaussing tool to an electrical outlet, while keeping the tool at least 61 centimeters (2 feet) away from the vehicle.
4. Slowly approach the center line of the roof panel at the rear liftgate, with the degaussing tool connected.
5. Contact the roof panel with the plastic coated tip of the degaussing tool. Be sure that the template is in place to avoid scratching the roof panel.
Using a slow, back-and-forth sweeping motion, and allowing 13 millimeters (0.50 inch) between passes, move the tool at least 11 centimeters (4
inches) to each side of the roof center line, and 28 centimeters (11 inches) forward of the rear liftgate.
6. With the degaussing tool still energized, slowly back it away from the roof panel. When the tip of the tool is at least 61 centimeters (2 feet) from
the roof panel, disconnect the tool.
7. Calibrate the compass, See: Accessories and Optional Equipment/Garage Door Opener Transmitter/Testing and Inspection/Programming and
Relearning/Programming Homelink(R) Transceiver Codes and adjust the compass variance, See: Accessories and Optional Equipment/Garage
