Liberty 2WD V6-3.7L (2008)
Marker Lamp: Service and Repair
Front Lamp Unit - Installation
LAMP
1. Position the front lamp unit (1) close enough to the front of the vehicle to reconnect the wire harness connections to the back of the lamp.
2. Position the lamp to the front end module carrier.
3. Install and tighten the four screws (2) that secure the front lamp unit to the front end module carrier. Tighten the screws securely.
4. Reinstall the grille onto the front of the vehicle. See: Body and Frame/Grille/Service and Repair/Grille - Installation.
5. Reconnect the battery negative cable.
6. Confirm proper headlamp alignment. See: Service and Repair/Procedures/Front Lamp Aiming.