Liberty 2WD V6-3.7L (2008)
Engine Control Module: Service and Repair
Powertrain Control Module - Installation
INSTALLATION
1. The PCM (Powertrain Control Module) (3-Right Hand Drive), or (3-Left Hand Drive) is located in the engine compartment.
2. Position PCM (3-Right Hand Drive), or (3-Left Hand Drive) to vehicle.
3. Install PCM mounting screws (4-Right Hand Drive), or (5-Left Hand Drive). Tighten screws to 8 Nm (71 in. lbs.) torque.
4. Connect PCM electrical connectors (5-Right Hand Drive), or (4-Left Hand Drive).
5. Connect negative battery cable.
CAUTION: Refer to PCM/ECM REPROGRAMMING for reprogramming procedures. If this step is not performed, a Diagnostic
Trouble Code (DTC) will be set.
CAUTION: Use the scan tool to reprogram the new PCM with the vehicles original identification number (VIN) and the vehicles original
mileage. If this step is not performed, a Diagnostic Trouble Code (DTC) will be set.