Liberty 2WD V6-3.7L (2008)
1. Reach under the front edge of the passenger side front seat cushion to carefully position the Occupant Classification Module (OCM) (1) to the top
of the mounting bracket (4) on the inboard passenger side front seat riser (2). When the OCM is correctly positioned, the connector receptacles on
the module will be pointed forward.
2. Install and tighten the two screws (3) that secure the OCM to the mounting bracket. Tighten the screws to 2 Nm (20 in. lbs.).
3. Reconnect the two seat wire harness connectors to the OCM connector receptacles located on the forward-facing end of the module. Be certain
that the latches on each connector are fully engaged.
4. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests.
5. Following successful completion of the SRS verification test procedure, perform the Occupant Classification System Verification Test See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Verification Tests/Occupant Classification Module (OCM) System Verification Test using a diagnostic scan tool.
