Liberty 2WD V6-3.7L (2008)
Sunroof / Moonroof Switch: Testing and Inspection
Full Open Retractable Roof Switch
FULL OPEN RETRACTABLE ROOF SWITCH
For complete circuit diagrams, refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire and
connector repair procedures, details of wire harness routing and retention, connector pin-out information and location views for the various wire harness
connectors, splices and grounds.
1. Remove the overhead console, See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Overhead Console - Removal.
2. Disconnect the full open retractable roof switch wire harness connector.
3. With the ignition key in the "RUN" position check for 5 volts on the "FRONT OPEN", "REAR OPEN" and "CLOSE" circuits of the switch
harness connector. If OK, go to STEP 4. If not OK, inspect the wiring harness and connectors for damage and repair as necessary.
4. With the ignition key in the "OFF" position check for continuity between the ground circuit of the switch harness connector and a known good
ground. Continuity should be present. If OK, go to STEP 5. If not OK, inspect the wiring harness and connector and repair the ground circuit as
necessary.
5. Using an ohmmeter, test the continuity of the full open retractable roof switch in each switch position. Refer to the FULL OPEN RETRACTABLE
ROOF SWITCH CONTINUITY TABLE. If OK, inspect the wiring harness and connectors for damage and repair as necessary. If not OK, replace
the overhead console assembly, See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Overhead Console - Removal.