Liberty 2WD V6-3.7L (2008)
26.
Install the A-pillar molding push pin (Figure 2).
27.
Position the cowl grille and engage the clips to the bottom of the windshield (Figure 1).
28.
Install the four push pins through the cowl grille and into the body (Figure 1).
29.
Install the hood seal (Figure 1).
30.
Install the wiper arms.
31.
Install the inside rear view mirror.
B. Quarter Glass Removal / Installation
IMPORTANT:
The use of sublet repair facilities for this recall is permitted as long as the glass and glass installation kits specified for this recall are used by the
repair technician.
1.
Remove the quarter trim panel as necessary to gain access to the glass seal from the inside.
2.
Cut the urethane bonding from around quarter glass using a suitable sharp cold knife. A pneumatic cutting device can be used if available.
CAUTION:
Use care not to damage paint.
3.
Remove and discard the glass from vehicle.
4.
Carefully clean and remove all of the old urethane bonding material from the quarter glass fence on the body.
5.
Using touch up paint, repair any scratches in the paint that may have been caused during glass removal.
6.
Clean the support spacers and install them onto the quarter glass (Figure 3).
7.
Clean the inside surface of the glass with Mopar® Glass Cleaner and lint-free cloth.
8.
Apply PVC (vinyl) primer 1 inch (25 mm) wide around the edge of the glass. Wipe with clean/dry lint-free cloth
9.
Apply fence primer around edge of the fence. Allow at least eighteen minutes drying time.
10.
Apply a 0.4 inch (10 mm) bead of urethane around the window vinyl border location.
11.
Install the adhesive backed spacers to the upper part of the quarter glass.
12.
Install the spacers to the lower part of the quarter glass (Figure 3).
13.
Position the quarter glass into the window opening and lock the clips into place.
14.
Install the quarter trim panel.
