Liberty 2WD V6-3.7L (2008)
6.
Using trim stick C-4755 or equivalent, remove the A-pillar push pin (Figure 2).
7.
Remove the windshield A-pillar molding and clips from the windshield A-pillar (Figure 2).
8.
Cut the urethane bonding from around the windshield using a suitable sharp cold knife. A pneumatic cutting device can also be used if available.
CAUTION:
Use care not to damage paint.
9.
Remove and discard the windshield from the vehicle.
10.
Carefully clean and remove all of the old urethane bonding material from the windshield fence on the body.
11.
Clean the support spacers and install them onto the weld studs at the bottom of the windshield opening.
12.
Place the replacement windshield into the windshield opening.
13.
Position the glass in the center of the windshield opening against the support spacers. Mark the windshield at the support spacers with a grease
pencil to use as a reference during installation.
14.
Remove the replacement windshield from windshield opening.
15.
Position the windshield with the inside surface of the glass facing upward on a suitable work surface with two 4 in. x 4 in. x 20 in. (10 cm x 10 cm
x 50 cm) padded wood blocks placed parallel 2.5 ft. (75 cm) apart under the windshield.
16.
Clean the inside surface of windshield with Mopar® Glass Cleaner and lint-free cloth.
17.
Apply clear glass primer 1 inch (25 mm) wide around edge of the windshield. Wipe with clean/dry lint-free cloth.
18.
Apply black-out primer .75 inch (15 mm) wide on top and sides of the windshield and 1 inch (25 mm) on the bottom of the windshield. Allow at
least three minutes drying time.
19.
Position adhesive backed spacers at the edge of the windshield opening.
20.
Apply a 0.4 inch (10 mm) bead of urethane around the perimeter of windshield.
21.
Apply fence primer around the perimeter of the windshield opening fence on the body. Allow at least 18 minutes drying time.
22.
With the aid of a helper, position windshield over windshield opening. Align reference marks at bottom of windshield to support spacers.
23.
Slowly lower windshield glass into the windshield opening fence. Guide the top molding into proper position if necessary. Push the windshield
inward to fence spacers at bottom and until top molding is flush to roof line.
24.
Clean excess urethane from exterior with Mopar(R) Super Clean or equivalent.
25.
Install the windshield A-pillar molding and clips to the windshield A-pillar (Figure 2).
