Liberty 2WD V6-3.7L (2008)
Windshield Washer Hose: Description and Operation
Description
Front
FRONT
Left-Hand Drive
Right-Hand Drive
The front washer plumbing consists of a small diameter rubber hose (8) that is routed from the barbed outlet nipple of the reversible electric washer
pump/motor unit on the washer reservoir on the left side of the engine compartment side by side with the rear washer hose and the front end module
wiring across the cooling module at the front to the right side of the engine compartment. The front washer hose is then routed along with the front end
module wiring across the top of the right front inner wheel house to the cowl plenum assembly where they pass through a rubber grommet in the front of
the plenum panel into the plenum area.
Within the plenum area, the front washer hose is connected by an in-line plastic connector to the hood washer hose (7). The hood hose is routed through
a rubber grommet (5) on left-hand drive vehicles, or through a metal S-clip (6) on right-hand drive vehicles out of the plenum area toward the upper
hinge bracket on the left side of the hood panel (1). Molded plastic routing clips and a metal S-clip secure the hoses to the upper hinge bracket and the
left side of the inner hood reinforcement. The washer nozzle hose is then secured within the rear channel bracket for the hood silencer on the underside
