Liberty 2WD V6-3.7L (2008)
9. Disconnect the wire harness electrical connector at the wiper motor (Figure 3).
10. Remove the two bolts that secure the ends of the front wiper module bracket to the cowl plenum (Figure 4).
11. Remove the nut that secures the front wiper motor bracket rubber insulator to the weld stud located on the bottom of the cowl plenum (Figure 4).
12. Remove the front wiper module from the cowl plenum as a unit
13. Transfer the wiper pivot assembly from the old wiper motor to the new wiper motor using the following procedure: