Liberty 2WD V6-3.7L VIN K (2003)
Body Control Module: Vehicle Damage Warnings
Electrical Testing Precautions
Electrical Testing Precautions
Before disconnecting any control module, make sure the ignition is "off". Failure to do so could damage the module.
When testing voltage or continuity at any control module, use the terminal side (not the wire end) of the connector. Do not probe a wire through the
insulation; this will damage it and eventually cause it to fail because of corrosion.
Be careful when performing electrical tests so as to prevent accidental shorting of terminals. Such mistakes can damage fuses or components. Also, a
second code could be set, making diagnosis of the original problem more difficult.
When replacing a blown fuse, it is important to use only a fuse having the correct amperage rating. The use of a fuse with a rating other than indicated
may result in a dangerous electrical system overload. If a properly rated fuse continues to blow, it indicates a problem in the circuit that must be
corrected.
Servicing Sub-Assemblies
Servicing Sub-Assemblies
Some components of the body system are intended to be serviced as an assembly only.
Attempting to remove or repair certain system sub-components may result in personal injury and/or improper system operation. Only those
components with approved repair and installation procedures should be serviced.
