Liberty 2WD V6-3.7L VIN K (2003)
Power Steering Line/Hose: Service and Repair
Hose - Pressure
Pressure Hose
REMOVAL
1. Siphon the power steering fluid from the reservoir.
2. Remove the radiator crossmember.
3. Remove the fan.
4. Remove the fan shroud.
5. Remove the serpentine belt.
6. Remove the pressure hose at the pump.
7. Disconnect the pressure switch electrical connector from the pressure hose.
8. Remove the pressure hose from the gear.
Fig. 9 Mounting Bracket
9. Remove the pressure hose mounting bracket bolts from behind the headlamp assembly.
10. Remove the pressure hose from the vehicle and transfer power steering pressure switch if necessary.
INSTALLATION
Fig. 12 High Pressure Hose Assembly
1. Install the pressure hose to the vehicle.
2. Install the pressure hose mounting bracket bolts behind the headlamp assembly. Tighten to 12 Nm (9 ft. lbs.).
3. Install the pressure hose to the gear. Tighten the hose to 28 Nm (21 ft. lbs.).
