Liberty 2WD V6-3.7L VIN K (2003)
17. Install the input clutch assembly into Input Clutch Pressure Fixture 8260 (Fig. 91). Mount a dial indicator to the assembly, push down on the
clutch discs and zero the indicator against the underdrive clutch discs (Fig. 92). Apply 20 psi of air pressure to the underdrive clutch and record
the dial indicator reading. Measure and record UD clutch pack measurement in four (4) places, 90° apart. Take average of four measurements and
compare with UD clutch pack clearance specification. The correct clutch clearance is 0.84 - 1.54 mm (0.033 - 0.061 in.). The reaction plate is not
selective. If the clutch clearance is not within specification, replace the reaction plate along with all the friction and steel discs.
18. Install the overdrive clutch pack into the input clutch retainer (Fig. 90). The overdrive steel separator plates can be identified by the lack of the
half-moon cuts in the locating tabs.
19. Install the overdrive clutch wavy snap-ring with the two tabbed ears into the input clutch retainer.
20. Install the OD/reverse reaction plate into the input clutch retainer. The reaction plate is non-directional (Fig. 90).
21. Install the OD/reverse reaction plate flat snap-ring into the input clutch retainer.
