Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
Trailer Tow Relay Remove/Install
6. Remove the appropriate relay by grasping it firmly and pulling it straight out from the connector bank.
INSTALLATION
1. Position the trailer tow relay to the appropriate connector in the connector bank.
2. Align the relay terminals with the receptacles in the connector.
3. Push firmly and evenly on the top of the relay until the terminals are fully seated in the connector.
4. Carefully restore the foam wrap around the trailer tow relay connector bank.
CAUTION: Use proper precautions to protect your skin and the rear body wire harness from cuts or scrapes caused by contact with the sharp
edges of the quarter inner panel sheet metal while servicing the trailer tow relay connector bank.
5. Reach through the access hole in the quarter inner panel behind the right rear wheelhouse to place the relay connector bank on the top of the right
rear wheelhouse between the quarter inner and outer panels.
6. Reinstall the trim onto the right side quarter inner panel.
7. Reconnect the battery negative cable.
