Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
Parking Brake Warning Switch: Description and Operation
Park Brake Switch
The park brake switch is located on the park brake lever mechanism on the floor panel transmission tunnel below the center floor console. This switch
includes a spade-type output terminal that connects the switch to the vehicle electrical system through a dedicated take out and connector of the body
wire harness. The output terminal is integral to the stationary contact within a molded plastic insulator. A locating tab on the insulator engages a slot in
the park brake lever mechanism for positive switch location. External to the insulator is a movable leaf contact with an integral grounding lug on one end
and an integral actuating lever and follower on the opposite end. The switch is secured to and grounded by a single screw to the park brake lever
mechanism. The park brake switch cannot be adjusted or repaired and, if faulty or damaged, it must be replaced.
The park brake switch is a normally closed, mechanically actuated leaf contact switch that is operated by the park brake lever mechanism. The switch is
grounded through its mounting to the park brake lever mechanism and provides a ground input to the ElectroMechanical Instrument Cluster (EMIC) on a
park brake switch sense circuit whenever the park brake is applied, and opens this circuit whenever the park brake is released. The park brake switch
sense input to the EMIC is used for control of the brake indicator and may also be used as a logic input for other electronic features in the vehicle.
The park brake switch can be diagnosed using conventional diagnostic tools and methods. However, proper testing of the EMIC processing of the park
brake switch sense input requires the use of a diagnostic scan tool.
