jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

System Description|Page 2738 > < System Description|Page 2736
Page 6
background image

Seat Class 2 (6 year old or Child)
Seat Class 3 (greater than or equal to 5th Percentile Female)
Seat Class 4 (less than 5th Percentile Female)
Seat Class 5 (Undetermined)

The DRB(R) III ACM Miscellaneous screen will display the following:

-

Configure Airbag On-Off Switch
1. No Airbag On-Off Switch
2. Pass OCM Only

OCS Menu 
The DRB(R) III OCM Input/Output screen will display the following:

-

OCS Status --- "0", "1", "2", "3", "4", "5"

The DRB(R) III OCM Sensors screen will display the following:

-

Bladder Output --- XXX A/D counts

-

Pas BTS Output --- XXX A/D counts

The DRB(R) III OCM OCS Info Monitor screen will display the following:

-

Pass BTS -- Enabled or Disabled

System Verification 
The DRB(R) III OCM System Test screen will display the following

-

PCM Monitor - PCM Active On The Bus or PCM Not Active On The Bus

-

Clear VIN Mismatch - Clear VIN Mismatch Complete

-

VIN Verification - Original VIN and Current VIN Clear VIN Mismatch

-

OCS Verification - OCS Verification

Test process errors:
Test In Progress
Mode 33 Not Supported
Subfunction not supported
Test Busy - Repeat Test
Conditions for Test Not Correct
Routine Already Running
Routine was Never Started
Press any key to continue, then restart the verification test.

Test failed conditions:
Test Failed - Active DTC's Present
Test Failed - Seat is Empty
Test Failed - Seat Occupied
Test Failed - Weight Above Threshold
Test Failed - Weight Below Threshold
Test Failed - Temperature Out of Range
Test Failed - Seat Pressure Too High
Test Failed - Seat Pressure Too Low
Test Failed - Seat Pressure Not Stable
Test Failed - Temperature Out of Range
Test Failed - Seat Pressure Too Low
Test Failed - Power Up Time Too Short
Test Failed - Power Up Time Too Long
Test Failed - K Empty Count is 0
Test Failed - No EOL Calibration
Test Failed - K Allow is FF

Allow the vehicle seat and interior temperature to stabilize, check voltage supplies and repair any other active DTC's before restarting the System
Verification test.

The OCS has been Verified or The OCS has NOT been Verified

WARNINGS:

-

TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND WAIT TWO
MINUTES BEFORE PROCEEDING.

-

TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNITION ON, THEN RECONNECT THE BATTERY.

System Description|Page 2738 > < System Description|Page 2736