Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
TPS Installation - 3.7L
The throttle shaft end of the throttle body slides into a socket in the TPS. The TPS must be installed so that it can be rotated a few degrees. (If sensor will
not rotate, install sensor with throttle
shaft on other side of socket tangs). The TPS will be under slight tension when rotated.
1. Install TPS and retaining screws.
2. Tighten screws to 7 N-m (60 in. lbs.) torque.
3. Connect TPS electrical connector to TPS.
4. Manually operate throttle (by hand) to check for any TPS binding before starting engine.
5. Install air cleaner tube to throttle body.
