Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
Front Transponder
FRONT TRANSPONDER
REMOVAL
1. Raise and support the vehicle.
2. Remove the front part wheel well housing cover and pull it back toward the tire to gain access to the transponder.
3. Remove the mounting nuts (1) for the transponder (2) from the mounting bracket. (Fig. 33).
4. Disconnect the electrical connector (3) and remove the transponder (2) from the vehicle (Fig. 33).
INSTALLATION
1. Reconnect the electrical connector (3) to the transponder (2). (Fig. 36)
2. Install the transponder (2) to the mounting bracket and install the mounting nuts (1) (Fig. 36).
3. Install the front part of the wheel well housing cover.
4. Lower the vehicle.
