Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
30.
Connect the tie rod end to the steering knuckle and install the supplied new retaining nut (Figure 8). Tighten the tie rod end retaining nut to 60 ft.
lbs. (81 Nm).
31.
On 2002 and 2003 model year vehicles, inspect the steering knuckle for the presence of a ball joint heat shield. Vehicles without heat shields must
have them installed (Figure 9).
32.
Repeat Steps 2 through 31 to replace the ball joint on the other side of the vehicle and then continue with Step 33.
33.
Install the right and left side wheel and tire assembly. Tighten the lug nuts to 100 ft. lbs. (135 Nm).
34.
Lower the vehicle from the hoist.
35.
Pump the brake pedal several times before moving the vehicle.
36.
Return the vehicle to the customer.
