Liberty 4WD L4-2.4L DOHC VIN 1 (2005)
Washer Fluid Level Switch: Service and Repair
REMOVAL
NOTE: The washer fluid level switch can be removed from the washer reservoir without removing the reservoir from the vehicle.
1. Disconnect and isolate the battery negative cable.
2. Siphon the washer fluid from the washer reservoir into a clean container for reuse.
3. Turn the steering wheel to move the front wheels to the full right position.
4. Raise and support the vehicle
5. Remove the plastic push-in fasteners that secure the forward end of the front wheelhouse splash shield to the inner fender panel and the front
fascia.
6. Pull the forward end of the front wheelhouse splash shield away from the inner fender panel and front fascia far enough to access the washer fluid
level switch for service.
Washer Fluid Level Switch Remove/Install
7. Disconnect the headlamp and dash wire harness connector for the washer fluid level switch from the switch connector receptacle.
8. Using a trim stick or another suitable wide flat-bladed tool, gently pry the barbed nipple of the washer fluid level switch out of the rubber grommet
seal on the reservoir just above the sump. Care must be taken not to damage the reservoir
9. Remove the washer fluid level switch from the washer reservoir
10. Remove the rubber grommet seal from the washer fluid level switch mounting hole in the washer reservoir and discard
INSTALLATION
1. Install a new rubber grommet seal into the washer fluid level switch mounting hole in the washer reservoir. Always use a new rubber grommet seal
on the reservoir.
2. Insert the float of the washer fluid level switch through the rubber grommet seal and into the washer reservoir. The connector receptacle of the
washer fluid level switch should be pointed downward.
3. Using hand pressure, press firmly and evenly on the washer fluid level switch mounting flange until the barbed nipple is fully seated in the rubber
grommet seal in the washer reservoir mounting hole.
4. Reconnect the headlamp and dash wire harness connector for the washer fluid level switch to the switch connector receptacle.
5. Reposition the forward end of the front wheel-house splash shield to the inner fender panel and the front fascia
6. Reinstall the plastic push-in fasteners that secure the front wheelhouse splash shield to the inner fender panel and the front fascia.
7. Lower the vehicle.
8. Reconnect the battery negative cable.
9. Refill the washer reservoir with the washer fluid siphoned from the reservoir during the removal procedure.
