Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
Tailgate Release Handle: Service and Repair
EXTERIOR HANDLE
REMOVAL
1. Remove the trim panel and waterdam as necessary to gain access to the handle.
2. Disconnect the lock switch and flip-up glass release electrical connectors.
3. Unclip the threaded clips and disconnect the actuator rods.
4. Remove the screws.
5. Remove the nuts and remove the handle.
INSTALLATION
1. Install the handle and hold tightly against the gate and support bracket.
2. Install the nuts and tighten to 6 N.m (55 in.lbs.).
3. Install the screws and tighten to 6 N.m (55 in.lbs.).
NOTE: Do not pre-load the latch rod when attaching. The latch and handle must be in a relaxed state when making the connection.
4. Connect the actuator rod by first pushing the rod into the stationary half of the threaded clip, then close the moving half ensuring the two halves
snap together fully.
5. Connect the lock switch and flip-up glass release electrical connectors.
6. Install the trim panel and waterdam.
