Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
15. Release the locking tab (1) that secures the blower motor (2) to the HVAC housing (3) and rotate blower motor counterclockwise.
16. Rotate the blower motor counterclockwise as needed to remove the blower motor and wheel from the HVAC housing.
17. Remove the two screws (1) that secure the blower motor resistor (2) to the rear of the HVAC housing (3) and remove the resistor.
NOTE: If the foam seal on the floor distribution duct is deformed or damaged, the seal must be replaced.
18. Remove the three screws (1) that secure the floor distribution duct (2) to the bottom of the HVAC housing (3) and remove the duct.
