Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
1. From the face of the inboard end cap (2), align the passenger airbag on/off indicator housing (1) with the mounting hole.
2. Using hand pressure, push the indicator firmly and evenly into inboard end cap until the two latches (4) are fully engaged on the back of the cap.
3. Position the indicator and end cap unit close enough to the instrument panel to reconnect the wire harness connector for the indicator to the
indicator connector receptacle (3). Be certain that the connector is fully engaged in the receptacle.
4. Align the indicator and end cap unit with the inboard end of the grab handle, and engage the lower snap feature of the end cap to the bottom of the
grab handle.
5. Using hand pressure, push the upper edge of the end cap firmly and evenly over the top of the grab handle until the cap snaps into place.
6. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
7. Following successful completion of the supplemental restraint system verification test procedure, perform the Occupant Classification System
Verification Test using a diagnostic scan tool.
