Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
Due to the ECM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKIM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. Check all modules using "Module Scan", record the DTC's, and erase these DTC's prior to returning
the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased.
NOTE:
The following step is required by law when reprogramming a ECM and/or TCM.
16. Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label.
REPAIR PROCEDURE FOR 2006 KJ VEHICLES USING wiTECH:
NOTE:
If this flash process is interrupted/aborted, the flash process should be restarted and then follow the directions on the wiTECH.
1. Reprogram the PCM with the latest software. Follow the detailed service procedures available in DealerCONNECT/TechCONNECT, Refer To
Group 8 - Electrical > Electronic Control Modules - Service Information > Module - Powertrain Control > Standard Procedures > PCM/ECM
Programming - Gas. After PCM reprogramming, the following must be performed:
a. Clear any DTC's that may have been set in other modules due to reprogramming. The wiTECH application will automatically present all DTCs
after the flash and allow the tech to clear them.
b. Reset the "Pinion Factor" as necessary.
c. Perform the transmission Quick Learn Procedure as necessary.
d. Update the Sentry Key Immobilizer Module (SKIM) or Sentry Key Remote Entry Module (SKREEM), Secret Key data if necessary.
2. Type the necessary information on the "Authorized Modification Label and attach it near the VECI label.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
