Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
3. Install and tighten the upper screw (5) that secures the side curtain airbag inflator bracket (8) to the U-nut (1) in the roof rail, followed by the lower
screw. Tighten the screws to 12 N.m (105 in. lbs.).
4. Working from the rear of the vehicle to the front, install and tighten each of the three screws that secure the side curtain airbag manifold tube
brackets to the U-nuts in the roof rail. Tighten the screws to 12 N.m (105 in. lbs.).
5. Route the side curtain airbag pigtail wire (4) through the trough along the top of the extruded plastic airbag channel on the roof side rail, then
between the channel and the body down the B-pillar (2).
NOTE: Be certain that the side curtain airbag pigtail wire is routed behind the airbag channel, between the channel and the body above the
B-pillar.
6. Engage the three side curtain airbag pigtail wire retainer clips (1) into the B-pillar.
7. Reconnect the side curtain airbag pigtail wire connector to the body wire harness connector (3) near the base of the B-pillar.
