Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
10. Remove the screw (2) that secures the retractor to the rear seat back panel (1).
11. Remove the rear center seat belt and retractor unit from the seat back panel.
INSTALLATION
1. Position the rear center seat belt and retractor unit onto the seat back panel (1).
2. Install and tighten the screw (2) that secures the retractor to the rear seat back panel. Tighten the screw to 27 N.m (20 ft. lbs.).
3. Position the seat back latch cable plunger (2) against the retractor latch lever (1), then engage the cable fitting (3) into the cable support (5) on the
retractor (4), which is a light snap fit.
4. Route the rear seat belt lower anchor and belt web guide through the top of the seat back panel.
5. Reinstall the trim onto the right rear seat back.
6. Install and tighten the two screws that secure the belt web guide to the top of the right rear seat back panel. Tighten the screws to 2 N.m (20 in.
lbs.).
7. Reinstall the right rear seat back panel into the vehicle.
