Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
CAUTION: Do not remove the wiring and terminals from the terminal cavities of the faulty PDC relay cassette at this time. Refer to the Assembly
procedure that follows for the proper procedures for transferring the wiring and terminals to the replacement PDC relay cassette.
1. Remove the relay wedge from the PDC relay cassette to be removed.
NOTE: It may be necessary to remove relay cassettes that are not being serviced from the PDC housing in order to obtain sufficient clearance to
access the faulty relay cassette. The same service procedure is repeated as necessary to remove each of the interfering relay wedges and relay
cassettes from the PDC housing.
2. From the top of the PDC housing, use a small screwdriver or a terminal pick tool (2) (Special Tool Kit 6680) to release the two latches (1) that
secure the relay cassette (3) in the PDC.
3. Gently and evenly press the relay cassette (3) down through the PDC housing.
4. From the bottom of the PDC housing (1), remove the relay cassette (2) from the PDC.
INSTALLATION
1. Move the faulty PDC relay cassette with its wiring away from the bottom of the PDC housing far enough to allow the replacement relay cassette to
be installed into the PDC.
2. Using the faulty relay cassette as a guide, be certain that the replacement relay cassette is correctly oriented before installing it into the PDC
housing.
