Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
c.
Install the two bolts holding the hood latch bracket to the bumper reinforcement and tighten to 85 in. lbs. (10 N·m).
d.
Install the five bolts securing the cross member. Tighten the bolts to 85 in. lbs. (10 N.m).
116. Install the grille.
117. Evacuate the A/C system.
118. Charge the A/C system with R-134A refrigerant.
119. Connect the negative battery cable.
120. Pour in 5 quarts of Mopar ATF+4 (PN 05013458AA or 05013457AA) into the transmission oil fill tube.
121. Start the vehicle and shift transmission through all gear ranges then back to NEUTRAL.
122. Bring the transmission fluid up to its normal operating temperature.
123. With the vehicle parking brake applied, engine running and the transmission in PARK, adjust the transmission fluid level as needed. needed.
124. Continue with either Section D for 2006 model year vehicles or Section E for 2005 model year vehicles.
D. Reprogram the ECM/TCM For 2006 MY Vehicles
NOTE:
This procedure must be performed with release 7.02 SP1 or later. To update your StarSCAN(R) diagnostic tool via the internet, the StarSCAN
software must be at version 7.02 and properly configured to work with your dealership¡Çs network. If the reprogramming flash for the ECM/TCM is
aborted or interrupted, repeat the procedure.
1.
Open the hood. Install a battery charger and verify that the charging rate provides 13.0 to 13.5 volts. If the battery charger is timer controlled, set
the battery charger to continuous charge. Do not allow the charger to time out during the flash process.
NOTE:
Use an accurate stand alone voltmeter. The battery charger volt meter may not be sufficiently accurate. Voltages outside of the specified range will
cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the headlamps and/or HVAC blower motor to lower
the voltage.
2.
Connect the CH9410 StarSCAN ethernet cable to the StarSCAN and the dealer's network drop.
3.
Connect the CH9404 StarSCAN vehicle cable to the StarSCAN and the vehicle.
4.
Place the Ignition in the "RUN" position, then Power "ON" the StarSCAN.
5.
Retrieve the old ECM part number. With the StarSCAN on the "Home" screen, follow the procedure below:
a.
Select "ECU View"
b.
Touch the screen to highlight "PCM" in the list of modules.
c.
Select "More Options".
d.
Select "PCM Flash".
e.
Record the "Part Number" displayed at the end of the "Resident flash file for" statement near the top of "Flash PCM" screen for later
reference.
6.
Download the flash file from the internet to the StarSCAN. With the StarSCAN on the "ECU Overview" screen, follow the procedure below:
a.
Select "Browse for New File". Follow the on screen instructions.
b.
If the newly downloaded flash file "Part Number" description is the same as the number recorded in Step 5e, then the PCM is up to date and
continue to Step 10. If the part number is different, continue with Step 6c.
c.
Highlight the listed calibration on the StarSCAN screen.
