Liberty 4WD L4-2.8L DSL Turbo VIN 5 (2006)
d.
Select "Download to Scantool".
e.
Select "Close" after the download is complete, then select "Back"
f.
Highlight the listed calibration.
g.
Select "Update Controller" and follow the on screen instructions.
h.
When the update is completed, select "OK".
7.
Disconnect the CH9404 StarSCAN vehicle cable from the vehicle. Wait until the StarSCAN screen reads "Vehicle Disconnected", then press
"OK".
8.
Reconnect the CH9404 StarSCAN vehicle cable to the vehicle.
9.
Retrieve the PCM part number. With the StarSCAN on the "Home" screen, follow the procedure below:
a.
Select "ECU View"
b.
Touch the screen to highlight "PCM" in the list of modules.
c.
Select "More Options".
d.
Select "PCM Flash".
e.
Verify the "Part Number" (displayed at the end of the "Resident flash file for" statement) has been updated to the new part number. If it has
updated, then the flash has been completed successfully.
10.
Retrieve the old TCM part number. With the StarSCAN on the "Home" screen, follow the procedure below:
a.
Select "ECU View"
b.
Touch the screen to highlight "TCM" in the list of modules.
c.
Select "More Options".
d.
Select "TCM Flash".
e.
Record the "Part Number" displayed at the end of the "Resident flash file for" statement near the top of "Flash TCM" screen for later
reference.
11.
Download the flash file from the internet to the StarSCAN. With the StarSCAN on the "ECU Overview" screen, follow the procedure below:
a.
Select "Browse for New File". Follow the on screen instructions.
b.
If the newly downloaded flash file "Part Number" description is the same as the number recorded in Step 10(e), then the TCM is up to date
and continue to Step 15. If the part number is different, continue with Step 11c.
c.
Highlight the listed calibration on the StarSCAN screen.
d.
Select "Download to Scantool".
e.
Select "Close" after the download is complete, then select "Back"
f.
Highlight the listed calibration.
g.
Select "Update Controller" and follow the on screen instructions.
h.
When the update is completed, select "OK".
12.
Disconnect the CH9404 StarSCAN vehicle cable from the vehicle. Wait until the StarSCAN screen reads "Vehicle Disconnected", then press
"OK".
13.
Reconnect the CH9404 StarSCAN vehicle cable to the vehicle.
