Liberty 4WD V6-3.7L (2009)
Antenna Cable: Service and Repair
Instrument Panel Antenna Cable - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag
system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag
system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Removal.
CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or
radio.
3. Disconnect the antenna cable from radio by pulling the locking antenna connector (2) away from radio.
4. Disengage each of the retainers that secure the cable to the instrument panel.
5. Remove the cable from the instrument panel.
