Liberty 4WD V6-3.7L (2009)
Rear Door Weatherstrip: Service and Repair
Rear Door Opening Seal - Installation
INSTALLATION
NOTE: Position the seal to the bottom of the door opening, with bulb facing outboard, starting the installation at the center of the lower
flange. Press the seal onto the sill flange and work around the perimeter of the door opening until fully seated. Work 1/2 the way
around and then start at the other end of the seal working back, making sure the splice joint has no gap and smoothing the seal to
avoid puckers or wrinkles. If in extreme cold temperatures preheating the weatherstrip to 23.8° C (75° F) may be required to fully
seat the weatherstrip.
1. Install the weatherstrip to the body mount flange.
2. Trim the weatherstrip if necessary, and connect the ends together along the flange.
