Liberty 4WD V6-3.7L (2009)
1. Open the lift gate.
NOTE: Align second clip from Right (Cross Car Locator) to its slot first. This helps line up the rest of clips.
2. Pull down at the center of the headliner molding (3) only enough to allow the tab (2) to be released from the quarter trim molding.
3. Carefully pull down to remove the remaining clips (4) attaching the molding to the body then move the molding to the left to released the tab from
the quarter trim molding.
Header Panel - Installation
INSTALLATION
1. Install the headliner molding (3) to the body by sliding the tab (1) on the right side into the quarter trim molding.
2. Pull down at the center of the headliner molding (3) only enough to allow the tab (2) to be slide into the other side of the quarter trim molding.
3. Using hand pressure snap the remaining clips (4) into place.
4. Close the lift gate.
Load Floor - Removal
REMOVAL
