Liberty 4WD V6-3.7L (2009)
1. Remove the seat belt bolt (3).
2. Using a trim stick C-4755 or equivalent, pry out the screw cover from the top of the trim panel (2), remove the screw.
3. Remove the trim (2) by sliding up and out of the quarter trim molding.
4. Remove the seatbelt webbing from the C-pillar trim (2).
C-Pillar Trim Panel-Installation
INSTALLATION
1. Feed the seatbelt webbing through the C-pillar trim (2).
2. Install the trim (2) by sliding down and into the quarter trim molding.
3. Align the 4-way locator and seat the C-pillar trim (2) to the body.
4. Install the screw and screw cover.
5. Install the seat belt bolt (3) and tighten to 62 Nm (46 ft. lbs.).
Shifter Bezel - Removal
REMOVAL
1. If equipped with a manual transmission and built before February 11, 2008, using a slide-hammer, snap out the shift knob from the lever.
