Liberty 4WD V6-3.7L (2009)
Keyless Start Antenna: Service and Repair
Remote Start Antenna - Removal
REMOVAL
WARNING: Disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, Occupant
Classification System (OCS), seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect
and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to follow these instructions may
result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the battery negative cable.
2. Remove but do not disconnect the right multi-function switch from the integral mounting bracket (1) on the right side of the clockspring and
position it so that the Sentry Key REmote Entry Module (SKREEM) (also known as the Sentry Key Immobilizer Module/SKIM or the Wireless
Control Module/WCM) mounting screw (2) may be accessed See: Sensors and Switches/Sensors and Switches - Wiper and Washer
Systems/Wiper Switch/Service and Repair/Right Multifunction Switch - Removal.
3. Disconnect the instrument panel wire harness connector (5) from the SKREEM (3) connector receptacle.
4. Remove the screw (2) that secures the SKREEM to the boss on the top of the ignition lock cylinder housing (6).
5. Disengage the SKREEM antenna ring from around the ignition lock housing and remove the SKREEM from the steering column.
6. Remove the coaxial electrical cable connector (4) from the SKREEM (3).
7. Remove the instrument cluster, refer to See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier/Service and
Repair/Removal and Replacement/Instrument Cluster - Removal.
NOTE: During removal of the remote start antenna note the routing location of the coaxial cable.
8. Remove the remote start antenna coaxial cable from mounting clips, if equipped.
9. Remove the screws (1) from remote start antenna module (2) and remove from instrument panel assembly.
