Liberty 4WD V6-3.7L (2009)
5. Position the forward lift arm (2) over the front drive assembly (3) and install the compression spring (1).
6. Lower the lift arm (2) and line up the hole in the lift arm with the hole (4) in the front drive assembly (3).
7. Insert the nylon pin (2) with the slot in the end in the horizontal position.
8. Seat the pin (2) fully.
9. Position the front drive assembly about 300 mm (12 inches) open.
10. Position the front of the cover down over the front drive assembly and seat fully.
11. Install the five screws (2), and seat the headliner hook and loop strip (3) fully.
12. Re-initialize ECU, See: Locks/Keyless Entry/Keyless Entry Module/Testing and Inspection
Rear Lift Arm and Bow Assembly
