Liberty 4WD V6-3.7L (2009)
1. Install the drive links (5) onto the drive assembly end caps (3) with the tear drops (2) toward the caps (3), the bevels (1) out and the nylon buttons
(4) up.
2. Push the drive cables into the tracks leaving the hole in the cable end (3) exposed.
NOTE: It may be necessary to twist the cables while pushing, to fully install the cables.
3. Insert the rear of the drive assembly (1) into the drive channel.
4. Connect the drive links (4) to the drive cable ends (3) and make sure that the nylon buttons (2) are facing up.
CAUTION: When moving the drive assemblies without the motors attached make sure that the assemblies are moved straight back.
5. Push the drive assembly back into the tracks.
6. Install the cam plates (2). See: Service and Repair/Removal and Replacement/Full Open Retractable Roof/Cam Plate - Installation
