Liberty 4WD V6-3.7L (2009)
8. Position the rear drive motor (1) up onto the motor mounting plate.
CAUTION: Do not install the motor using any twisting motion. Always install the motor straight and use the screws to draw the drive gear
into the drive cables.
NOTE: When ever the motors are removed, the screws (2) need to be discarded and replaced with new service screws and washers.
9. Install the motor screws (2) and draw the motor up evenly using the motor screws.
10. Connect the electrical connector.
11. Clean the tracks (1), See: Interior Moulding / Trim/Headliner/Service and Repair/Full Open Retractable Roof
NOTE: Apply 5 grams of Nyogel 729F Grease to the drive track only (3).
12. Install the top assembly and sliders (2) back to front into the tracks (1) and slide back unrolling the top as you proceed.
