Liberty 4WD V6-3.7L (2009)
5. Position the rear drive motor (1) up onto the motor mounting plate.
CAUTION: Do not install the motor using any twisting motion. Always install the motor straight and use the screws to draw the drive gear
into the drive cables.
NOTE: When ever the motors are removed, the screws (2) need to be discarded and replaced with new service screws and washers.
6. Install the motor screws (2) and draw the motor up evenly using the motor screws.
7. Connect the electrical connector.
8. Manually position the rear drive assembly about 300 mm (12 inches) open, See:
9. Position the rear of the cover down over the rear drive (1) and seat fully.
10. Install the five screws (2).
11. Line up the headliner (3) center notch with the center screw (2) and seat the headliner hook and loop strip (3) fully.
