Liberty 4WD V6-3.7L (2009)
6. Insert the cushion assembly (1) fully into the biteline (2) of the seat.
NOTE: It is important that the foam be fully seated on the frame so a leather bubble does not appear. Pull rearward on the wire embedded in
the rear of the foam to assist in locating the foam correctly.
7. Connect the electrical connectors, if equipped.
8. Secure the front and back J-straps (1) fully.
9. Tuck the edges of the cover under the collar on the side shields in back.
10. Secure the side J-straps fully.
11. Install the seat side shields. See: Seat Cushion/Service and Repair/Seat Cushion Side Shields - Installation
Rear
INSTALLATION
60/40 Seat Cushion - 60