Liberty 4WD V6-3.7L (2009)
Brake Pedal Assy: Service and Repair
Brake and/or Accelerator Pedals - Installation
INSTALLATION
1. Lubricate the brake pedal pin and bushings with Mopar multi-mileage grease.
2. Install the pedal bushings if removed.
3. Install the pedal into the vehicle.
4. Install the nuts securing the pedal to the column bracket.
5. Tighten the nuts to 22.6 Nm (200 in. lbs.).
6. Install the booster push rod on the pedal pin and install a new retainer clip (3).
CAUTION: Do not reuse the original stop lamp switch. Anytime a switch has been removed or its position compromised, a new switch must be
installed and adjusted. Do not attempt to readjust the switch.
7. Install and adjust a NEW stop lamp switch, See: Lighting and Horns/Brake Light Switch/Service and Repair/Stop Lamp Switch - Installation.
8. Install the knee blocker, See: Restraint Systems/Knee Diverter/Service and Repair/Kneeblocker - Installation.
