Liberty 4WD V6-3.7L (2009)
No
-
Go To 10
10. FUEL PUMP MODULE/TIPM
1. Connect the C3 PCM harness connector.
2. Connect the C1 and C5 TIPM harness connectors.
3. Turn the ignition on.
4. Using a scan tool actuate the Fuel Pump Module.
5. Using a 12-volt test light connected to ground, probe the (N1) Fused Fuel Pump Output circuit at the Fuel Pump Module harness connector.
Does the test light illuminate?
Yes
-
Replace the Fuel Pump Module. See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Removal and
Replacement/Fuel Tank - Removal.
-
Perform the POWERTRAIN VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Powertrain Verification Test.
No
-
Replace the Totally Integrated Power Module.
-
Perform the POWERTRAIN VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Powertrain Verification Test.
11. POWERTRAIN CONTROL MODULE (PCM)
NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.
1. Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.
Were there any problems found?
Yes
-
Repair as necessary.
-
Perform the POWERTRAIN VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Powertrain Verification Test.
No
-
Replace and program the Powertrain Control Module.
-
Perform the POWERTRAIN VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Powertrain Verification Test.
