Liberty 4WD V6-3.7L (2009)
in. lbs.).
10. Position the blower motor resistor (5) into the HVAC housing and install the two retaining screws (1). Tighten the screws to 1.2 Nm (10 in. lbs.).
11. Install the air inlet housing (3) onto the HVAC housing (2) See: Removal and Replacement/HVAC Housing - Installation.
12. Install the air distribution housing (1) onto the HVAC housing See: Removal and Replacement/HVAC Housing - Installation.
13. Install the passenger side lower front floor duct See: Air Duct/Service and Repair/Floor Distribution Duct - Installation.
NOTE: If the heater core is being replaced, flush the cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair .
14. Install the HVAC housing assembly See: Removal and Replacement/HVAC Housing - Installation.
15. If the A/C evaporator is being replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system. When replacing multiple A/C
system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be added to the refrigerant system See: Service
and Repair/Refrigerant Oil Level. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
