Liberty 4WD V6-3.7L (2009)
Refrigerant Pressure Sensor / Switch: Service and Repair
A/C Pressure Transducer - Removal
REMOVAL
NOTE: It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.
NOTE: LHD model shown. RHD model similar.
1. Disconnect and isolate the negative battery cable.
2. Disconnect the wire harness connector (1) from the A/C pressure transducer (2) located on the A/C liquid line (3) near the dash panel (4) in the
engine compartment.
3. Remove the A/C pressure transducer from the A/C liquid line and remove and discard the O-ring seal.