Liberty 4WD V6-3.7L (2009)
For proper diagnosis of the no fuse indicator, the TIPM, the EMIC, the CAN data bus or the electronic communication related to no fuse indicator
operation a diagnostic scan tool is required. Refer to the appropriate diagnostic information.
Service 4WD Indicator - Description
DESCRIPTION
A service 4WD indicator is standard equipment on all instrument clusters. However, on vehicles not equipped with the optional four-wheel drive system
and electronically shifted transfer case, this indicator is electronically disabled. This indicator is located above the engine coolant temperature gauge on
the cluster overlay, to the right of the tachometer.
The service 4WD indicator consists of a stencil-like cutout of the text SERV 4WD in the opaque layer of the instrument cluster overlay. The dark outer
layer of the overlay prevents the indicator from being clearly visible when it is not illuminated. An amber Light Emitting Diode (LED) behind the cutout
in the opaque layer of the overlay causes the indicator to appear in amber through the translucent outer layer of the overlay when it is illuminated from
behind by the LED, which is soldered onto the instrument cluster electronic circuit board.
The service 4WD indicator is serviced as a unit with the instrument cluster.
Service 4WD Indicator - Operation
OPERATION
The service 4WD indicator gives an indication to the vehicle operator when the Totally Integrated Power Module (TIPM) has recorded a Diagnostic
Trouble Code (DTC) for an electronic transfer case circuit or component malfunction. This indicator is controlled by a transistor on the instrument
cluster circuit board based upon cluster programming and electronic messages received by the cluster over the Controller Area Network (CAN) data bus.
The service 4WD indicator Light Emitting Diode (LED) is completely controlled by the instrument cluster logic circuit, and that logic will only allow
this indicator to operate when the instrument cluster receives a battery current input on the fused ignition switch output (run-start) circuit. Therefore, the
LED will always be OFF when the ignition switch is in any position except ON or START. The LED only illuminates when it is provided a path to
ground by the instrument cluster transistor. The instrument cluster will turn ON the service 4WD indicator for the following reasons:
-
Bulb Test - Each time the ignition switch is turned to the ON position the service 4WD indicator is illuminated for about two seconds as a bulb
test.
-
Service 4WD Indicator Lamp-On Message - Each time the cluster receives an electronic service 4WD indicator lamp-ON message from the
TIPM, the service 4WD indicator will be illuminated. The indicator remains illuminated until the cluster receives a lamp-OFF message from the
TIPM, or until the ignition switch is turned to the OFF position, whichever occurs first.
-
Communication Error - If the cluster receives no lamp-ON or lamp-OFF messages from the TIPM for 10 seconds, the service 4WD indicator is
illuminated by the cluster to indicate a loss of TIPM communication. The indicator remains controlled and illuminated by the cluster until a valid
message is received from the TIPM.
-
Actuator Test - Each time the cluster is put through the actuator test, the service 4WD indicator will be turned ON, then OFF again during the
bulb check portion of the test to confirm the functionality of the LED and the cluster control circuitry.
The TIPM continually monitors the electronic transfer case control circuits and transfer case shift motor/mode sensor assembly to determine the
condition of the system. The TIPM then sends the proper lamp-ON or lamp-OFF message to the ElectroMechanical Instrument Cluster (EMIC).
For proper diagnosis of the TIPM, the EMIC, the CAN data bus or the electronic communication related to service 4WD indicator operation a diagnostic
scan tool is required. Refer to the appropriate diagnostic information.
Transmission Temperature Indicator - Description
DESCRIPTION
A transmission over-temperature indicator is standard equipment on all instrument clusters. However, on vehicles not equipped with an optional
automatic transmission, this indicator is electronically disabled. This indicator is located above the engine coolant temperature gauge on the cluster
overlay, to the right of the tachometer.
