Liberty 4WD V6-3.7L (2009)
Cargo Lamp Bulb: Service and Repair
Courtesy Lamp - Installation
BULB
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or
instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two
minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable
the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
1. Align the base of the bulb (3) with the courtesy lamp socket.
2. Push the bulb straight into the lamp socket until the base is firmly seated.
3. Align the lens (4) with the courtesy lamp unit housing (1).
4. Support the lamp housing with one hand while firmly and evenly pushing the lens into the housing with the other hand, until the lens snaps into
place.
5. Reconnect the battery negative cable.
