Liberty 4WD V6-3.7L (2009)
Hose/Line HVAC: Service and Repair
A/C Discharge Line - Removal
3.7L ENGINE
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Heating and Air
Conditioning/Service Precautions/Warning and See: Heating and Air Conditioning/Service Precautions/Caution . Failure to follow these
instructions may result in possible serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Recovery.
3. Remove the air cleaner housing.
4. Remove the nut (2) that secures the A/C discharge line (3) to the A/C compressor (4).
5. Disconnect the A/C discharge line from the A/C compressor and remove and discard the O-ring seal and gasket.
6. Remove the grille See: Body and Frame/Grille/Service and Repair/Grille - Removal.
7. Remove the nut (4) that secures the A/C discharge line (5) to the A/C condenser (3).
8. Remove the bolt (2) that secures the A/C condenser to the right side of the radiator (1).
9. For clearance, position the A/C condenser toward the left side of the vehicle and then disconnect the A/C discharge line from the condenser.
10. Remove and discard the O-ring seal and gasket from the discharge line fitting.
11. Remove the A/C discharge line from the engine compartment and install plugs in, or tape over the opened discharge line fittings and the
compressor and condenser ports.
A/C Discharge Line - Installation
3.7L ENGINE
CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system See: Heating and Air Conditioning/Service
