Liberty 4WD V6-3.7L (2009)
NOTE: The main fuel pump module must be properly located in the fuel tank for the fuel level gauge to work properly.
3. Align the rubber O-ring seal and rotate the fuel pump module to the orientation marks noted during removal. This step must be performed for the
fuel level gauge to work properly.
4. Position the lock-ring over top of the fuel pump module.
5. Position the lock-ring remover/installer 9340 into the notches on the outside edge of the lock-ring.
6. Install a 1/2 inch drive breaker bar into the lock-ring remover/installer 9340.
7. Rotate the breaker bar clockwise until all seven notches of the lock-ring have engaged.
8. Install the fuel tank See: Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Removal and Replacement/Fuel Tank - Installation.
