Liberty 4WD V6-3.7L (2009)
observe this warning could result in accidental, incomplete, or improper side SRS component deployment.
NOTE: The front and side impact sensors are interchangeable.
1. Reconnect the body wire harness connector (4) to the side impact sensor (3) connector receptacle.
2. Position the sensor onto the weld stud on the inner B-pillar (1). Be certain that the anti-rotation pin on the back of the sensor is engaged in the
clearance hole of the B-pillar.
3. Install and tighten the nut (2) that secures the sensor to the weld stud on the inner B-pillar. Tighten the nut to 7 Nm (62 in. lbs.).
4. Reinstall the lower trim onto the inside of the B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel-Installation.
5. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Service and Repair.
Side - C-Pillar
SIDE - C-PILLAR
WARNING: Disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, Occupant
Classification System (OCS), seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect
and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to follow these instructions may
result in accidental airbag deployment and possible serious or fatal injury.
WARNING: To avoid serious or fatal injury, never strike or drop the side impact sensor, as it can damage the impact sensor or affect its
calibration. The side impact sensor enables the system to deploy the side Supplemental Restraint System (SRS) components. If an
impact sensor is accidentally dropped during service, the sensor must be scrapped and replaced with a new unit. Failure to
observe this warning could result in accidental, incomplete, or improper side SRS component deployment.
NOTE: The front and side impact sensors are interchangeable.